By Nick Forrest|2020-08-14T11:40:57-07:00August 14th, 2020|General Questions|Comments Off on Architect Specifications
Am I able to Install on the Interior?
Interior SLIP™ Install There are a few items you should be aware of if you wish to install SLIPs on the interior side of sash? Will the installation of SLIPs on the interior face of the sash interfere with any hardware? If hardware is in the way, mometimes hardware can be moved to [...]
Where does the SLIP™ sit on the sash?
The SLIP™ extrusion inside edge should meet and sit on the the outside edge of the putty glazing but should not extend further over the putty. The SLIP will extend 3/4 inch to the edge of the sash from the outside edge of the putty glazing and sit approximately 1/4 inch above the face [...]
Where Can I Learn About Lead Paint?
Click the link to take you to the PDF Pamphlet from the EPA for information about lead paint. EPA Pamphlet
Have you done testing on the SLIP™?
Yes, extensive testing on the product versus substitute product was done by the University of Oregon's 'Energy Studies on Building Laboratory. Results of that study can be seen HERE
Will a SLIP cause fog or condensation?
SLIPs wont cause any fogging due to vent holes evenly placed. This allows for for an even air pressure between both panes and on the exterior. SLIPs may fog about a week after installation, this is due to the chemicals in the cleaning solution that was used on the glass, this should subside in [...]
How much do SLIPs weigh?
SLIPs weigh approximately 1 ¾ lb per square foot.
Can I install a SLIP™ on an irregular shaped window?
Currently we only make SLIPs to fit on square and rectangular shaped windows.
What color options are available?
SLIP™ Extrusions are painted with PPG product. Current colors are as follows: Delicate White-PPG1001-1 Bronzed Carmel- MTL140 Pearl (Yellow-Beige)- PPG1087-2
Will hardware be an issue for installation?
You must check to make sure hardware will not be an issue for successful installation. SLIPs sit approx 1 inch outside the daylight of a window. If the hardware is not fixed, hardware can be moved to remedy spacial issues for successful installation. A certified installer will access possible hardware challenges during initial evaluation. [...]