Am I able to Install on the Interior?

Interior SLIP™ Install   There are a few items you should be aware of if you wish to install SLIPs on the interior side of sash?   Will the installation of SLIPs on the interior face of the sash interfere with any hardware? If hardware is in the way, mometimes hardware can be moved to [...]

By |2019-11-19T14:06:59-08:00November 19th, 2019|, , |Comments Off on Am I able to Install on the Interior?

I received the wrong size SLIP™

If you believe your SLIP™ to be the wrong size, please take a photo of the SLIP™ with a measuring tape showing the size received and forward to us at support@windowslip.com. We will re-make and replace the SLIP™ in question at no charge.

By |2019-05-10T13:49:26-07:00May 10th, 2019||Comments Off on I received the wrong size SLIP™

Where does the SLIP™ sit on the sash?

The SLIP™ extrusion inside edge should meet and sit on the the outside edge of the putty glazing but should not extend further over the putty.  The SLIP will extend 3/4 inch to the edge of the sash from the outside edge of the putty glazing and sit approximately 1/4 inch above the face [...]

By |2019-05-07T15:51:52-07:00May 7th, 2019|, , |Comments Off on Where does the SLIP™ sit on the sash?

Will a SLIP cause fog or condensation?

SLIPs wont cause any fogging due to vent holes evenly placed. This allows for for an even air pressure between both panes and on the exterior. SLIPs may fog about a week after installation, this is due to the chemicals in the cleaning solution that was used on the glass, this should subside in [...]

By |2019-04-10T10:45:02-07:00March 6th, 2019||Comments Off on Will a SLIP cause fog or condensation?

What If a break a SLIP™

You can hold onto the extrusions and get another piece of tempered glass to match the extrusion size from your local glass shop. If a SLIP™ smaller than 50" for width and for height you can purchase another SLIP™ from us. Slips larger than 25 square feet must have 1/4 inch glass [...]

By |2019-04-08T15:55:04-07:00February 14th, 2019||Comments Off on What If a break a SLIP™

What is the Relationship of the installer?

Approved installers are their own separate licensed business that perform and provide their own services. These installers have been vetted for their scope and proper licensing.  The installer has no authority to and will not exercise or hold itself out as having any authority to enter into or conclude any contract or to undertake [...]

By |2019-11-19T12:43:02-08:00December 27th, 2018||Comments Off on What is the Relationship of the installer?